Author: Cameron Coward
-
Releasing QuestScribe!
This is for my fellow writers: https://github.com/theserialhobbyist/questscribe It is a free and open-source word processor designed specifically for writing LitRPG. I decided to make this after noticing that I struggled to keep track of all the various stats in my own novel and I thought others might benefit, too. The big feature is stat-tracking. You…
-
Open-Source DIY Remote for DJI Osmo Action 5 Pro Cameras
An open-source DIY remote control, based on the M5StickC Plus2, for DJI Osmo Action 5 Pro cameras. This is part of a much larger project, but I wanted to share it because there don’t seem to be any other DIY remotes out there. It can sleep/wake the camera, switch modes, start/stop recording, capture photos, and…
-
Open-Source DIY Remote for Insta360 Cameras
I created this open-source remote, based on M5StickC devices, for Insta360 cameras. It lets you switch modes, start/stop recording, capture photos, put the camera to sleep, and wake the camera up. Also accepts external GPIO control: Pull G0 to GND to trigger the shutter/recording. Pull G26 to HIGH to put the camera into SLEEP mode.…
-
CamRo – An Open-Source Camera Robot
I built this robot to help capture awesome videos of things I make. It is completely open-source. You can find all of the instructions and files on Hackster. And watch my YouTube video about it:
-
-
How to Use a Tecnomagnete QX303UMK6 EPM Chuck with an ST120F (ST100) Controller
My solution to connect an Tecnomagnete QX303UMK6 EPM (Electro-Permanent Magnet) chuck to an ST120F controller.
-
Barker Horizontal Mill CNC Conversion
In this video, I clean up a Barker PM horizontal mill convert it to CNC.
-
The Bear Claw: an Input Device for Davinci Resolve
This is an editing controller macro pad thing I designed and built specifically for speeding up my video editing workflow in Davinci Resolve.
-
How to Disable the Chuck Shield Safety Switch on Mini Lathes
How to disable the chuck shield disconnect switch on Vevor (and other) mini lathes.
-
How to Convert .NC to .JG for Suda CNC Machines
An explanation of how to convert g-code files to .jg files for use with Suda CNC machines.
-
How to Install ROS2 on a Raspberry Pi 5
This is how you can install ROS2 (Jazzy Jalisco) on a Raspberry Pi 5, easily and without using Docker.
-
Elecrow CrowView Note Review
If you work with Raspberry Pis or other single-board computers, then you’ll want to check out my review of the Elecrow CrowView Note.